 |
|
Place the parts for
ONLY
the
canopy frame
in the center of where your canopy will stand. Lay a
top upright in each corner making sure you put the two with
an "L" stamped into the cast corner piece at what will be
the left FRONT corner and the RIGHT back corner of your
booth. This will put them diagonal from each other.
Now place the two with a "R" stamped into the cast corner
piece at the two remaining corners. |
| |
|
|
|
|
Telescope out
ONE
horizontal side pole. Place this horizontal pole in a
top upright, making sure the button pops out from the hole.
Place another horizontal pole <do
not pre-telescope this pole>
into the same top upright, making sure the button pops out
from the hole. With the bottom of the upright and the
free end of the telescoped out horizontal pole both resting
on the ground, telescope out the horizontal pole you just
put into the top upright.
|
| |
|
|
 |
|
Lift the top
upright with the horizontal poles attached and place in
first corner. You now have 1/2 of your frame
assembled.
Continue to
assemble the remaining top uprights and horizontal poles
until you have a 10'x10' square.
Assemble the
X-member by forming a "X" and tightening the nut and bolt in
the center.
|
|
|
Insert three
curved ridge members into each corner upright and into the
x-member. Now insert the fourth ridge member in the
x-member. Place your foot at the bottom of the bottom
upright, bring the leg towards center of frame and insert
this fourth ridge member.
|
| |
|
|
|
|
Attach
four s-hooks to each side curtain. Use pliers to
secure the s-hooks to the side curtains. Attach the
side curtains with the, "Made in USA" labels on the inside.
You will find three holes in the cast corner piece of
each upright. The two outside holes are where you
attach the curtain s-hooks. |
| |
|
|
 |
|
Unfold your canopy top and
with the Light-Dome® label on the outside, throw as much of
the material over the frame as possible. You'll find
it easier to go under the frame and distribute the material
to each corner. Pull down the corners using both
hands. The top will be tight. Wrap the corner
straps with snaps around the top uprights and fasten
underneath the heavy corner cast pieces. |
| |
|
|
|
|
f you DO NOT have any
accessories for your canopy, you are now ready to telescope
the canopy up. Start at one corner and pick the
upright up. Hold the upright in one hand and use your
other hand to lower the bottom upright out of the top,
keeping the hole in the foot pointing outward, until the
button is at the holes. Repeat this for the three
remaining legs. If you have additional accessories,
refer to their specific instructions
BEFORE
raising your canopy up. |
| |
|
|
| |
|
|
