Place the parts for ONLY the canopy frame in the center of where your canopy will stand.  Lay a top upright in each corner making sure you put the two with an "L" stamped into the cast corner piece at what will be the left FRONT corner and the RIGHT back corner of your booth.  This will put them diagonal from each other.  Now place the two with a "R" stamped into the cast corner piece at the two remaining corners.

Telescope out ONE horizontal side pole.  Place this horizontal pole in a top upright, making sure the button pops out from the hole.  Place another horizontal pole <do not pre-telescope this pole> into the same top upright, making sure the button pops out from the hole.  With the bottom of the upright and the free end of the telescoped out horizontal pole both resting on the ground, telescope out the horizontal pole you just put into the top upright.

Lift the top upright with the horizontal poles attached and place in first corner.  You now have 1/2 of your frame assembled.

Continue to assemble the remaining top uprights and horizontal poles until you have a 10'x10' square.

Assemble the X-member by forming a "X" and tightening the nut and bolt in the center.

Insert three curved ridge members into each corner upright and into the x-member.  Now insert the fourth ridge member in the x-member.  Place your foot at the bottom of the bottom upright, bring the leg towards center of frame and insert this fourth ridge member.

Attach four s-hooks to each side curtain.  Use pliers to secure the s-hooks to the side curtains.  Attach the side curtains with the, "Made in USA" labels on the inside.  You will find three holes in the cast corner piece of  each upright.  The two outside holes are where you attach the curtain s-hooks.

The shorter straps with snaps at the top of the side curtains go around the horizontal frame poles.  Roll up the side curtains and use the longer straps with snaps to hold them up in place.

Unfold your canopy top and with the Light-Dome® label on the outside, throw as much of the material over the frame as possible.  You'll find it easier to go under the frame and distribute the material to each corner.  Pull down the corners using both hands.  The top will be tight.  Wrap the corner straps with snaps around the top uprights and fasten underneath the heavy corner cast pieces.

If you DO NOT have any accessories for your canopy, you are now ready to telescope the canopy up.  Start at one corner and pick the upright up.  Hold the upright in one hand and use your other hand to lower the bottom upright out of the top, keeping the hole in the foot pointing outward, until the button is at the holes.  Repeat this for the three remaining legs.  If you have additional accessories, refer to their specific instructions BEFORE raising your canopy up.